TL;DR: To change the oil in a 2018 Honda Accord, drain the old oil from the undercarriage after removing the drain plug, then replace the oil filter with a new one. Finally, refill the engine with five quarts of 0W-20 synthetic oil and check the level using the dipstick or electronic monitor.
Preparation and Safety
Before you begin, ensure your vehicle is parked on a level surface with the engine cool to the touch. Gather your supplies: a new oil filter specific to the 2018 Accord, five quarts of 0W-20 full synthetic oil, a new drain plug washer, a 17mm socket for the drain plug, an oil filter wrench, and a drain pan. Safety is paramount; always wear gloves and eye protection when handling hot or dirty fluids.
If you want to dig deeper, check out our guide on Is Bone Broth Concentrate Healthy? Benefits & Truth.
Draining the Old Oil
First, pop the hood and remove the oil filler cap to allow air into the system, which helps the oil drain faster and more completely. Next, locate the oil drain plug on the bottom of the oil pan. It is typically accessible from underneath the vehicle. Place your drain pan directly beneath the plug. Using your 17mm socket, carefully loosen the drain plug. Once loose, finish unscrewing it by hand to avoid stripping the threads or dropping the bolt into the pan. Allow the oil to drain completely; this may take ten to fifteen minutes. While it drains, you can prepare the new filter.
Replacing the Oil Filter
Locate the oil filter, which is usually mounted vertically near the front of the engine block. Use your oil filter wrench to loosen and remove the old filter. Be prepared for some residual oil to spill out. Before installing the new filter, apply a thin layer of fresh oil to the rubber gasket of the new filter. This ensures a proper seal and makes future removal easier. Screw the new filter on by hand until the gasket contacts the engine, then tighten it an additional three-quarters of a turn. Do not over-tighten, as this can damage the gasket or make removal difficult later.
Refilling and Checking
Once the oil has finished draining, reinstall the drain plug with your new washer. Tighten it to the manufacturer’s specified torque, usually around 30 foot-pounds, to prevent leaks. Lower the vehicle if you were on a lift or jack stands. Pour five quarts of 0W-20 oil into the engine through the filler opening. Replace the cap and start the engine. Let it run for a minute to circulate the new oil and check for leaks around the filter and drain plug. Turn off the engine and wait a few minutes for the oil to settle. Check the level using the electronic oil life monitor or the dipstick if equipped. Top off if necessary. Dispose of the old oil at a recycling center. Regular maintenance keeps your Accord running smoothly for years.
FAQ
Q: How often should I change the oil in my 2018 Honda Accord?
A: Honda recommends changing the oil every 7,500 miles or twelve months, whichever comes first, when using full synthetic 0W-20 oil.
Q: Can I use conventional oil instead of synthetic in a 2018 Accord?
A: It is not recommended; the manufacturer specifies 0W-20 full synthetic oil for optimal engine performance, fuel efficiency, and protection in modern engines.
Q: What size socket do I need to remove the drain plug?
A: You will typically need a 17mm socket or wrench to remove and reinstall the oil drain plug on a 2018 Honda Accord.
Leave a Reply